Totally new to this .
I'm looking to build ring lights that I can remotely change the RGB led to enhance the photos of a high speed camera.
Not sure where to begin
Extremely bright Led RGB ring light to build
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- adafruit_support_bill
- Posts: 88155
- Joined: Sat Feb 07, 2009 10:11 am
Re: Extremely bright Led RGB ring light to build
This might be a god place to start: https://learn.adafruit.com/3d-printed-camera-led-ring
- RBDigital
- Posts: 5
- Joined: Wed Nov 19, 2014 1:24 am
Re: Extremely bright Led RGB ring light to build
Use the above and encorporate http://www.bhoite.com/2014/08/spark-core-neopixel-app/
I've already done this and it works really well. Below is my image.
Issues I found where the 3D printed in the 60 ring where slightly big and needed to add a wire bridge to make the ring slightly bigger, some of the parts in the hot shoe are a little loose and need some extra wedged pieces to hold it in tight and I still need to find something proper to hold the arm to the ring housing.
I also used a 4G portable hub to connect my sparks core and a 5000mAh battery pack to power the core and the pixels. I've made it completely portable.
I've already done this and it works really well. Below is my image.
Issues I found where the 3D printed in the 60 ring where slightly big and needed to add a wire bridge to make the ring slightly bigger, some of the parts in the hot shoe are a little loose and need some extra wedged pieces to hold it in tight and I still need to find something proper to hold the arm to the ring housing.
I also used a 4G portable hub to connect my sparks core and a 5000mAh battery pack to power the core and the pixels. I've made it completely portable.
Please be positive and constructive with your questions and comments.