I want to buy a German analog synth, but it is designed for 220 v, so to use it here in the U.S., I could just use a voltage converter, right? I just want to make sure I won't fry any expensive circuits.
-Josh
Question about 220 to 110 volt power converters
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
-
- Posts: 7
- Joined: Sat Jun 30, 2007 1:49 pm
-
- Posts: 12151
- Joined: Thu Apr 06, 2006 4:21 pm
Re: Question about 220 to 110 volt power converters
yup, you want a transformer power converter
-
- Posts: 3
- Joined: Sun Feb 22, 2009 2:22 pm
Re: Question about 220 to 110 volt power converters
Transformer converter is the way to go, however...
If it's a recent synth, check the back of the unit to see if it accepts 110V/60Hz. Most recent electronic devices will accept a range of voltages from 100V to 240V without hassle, but IT SHOULD BE MARKED ON THE UNIT. (Putting this in caps to make sure you check )
If it's an older unit (pre-1990s), go for the transformer option. If it's a more recent unit, check the voltage rating sticker on the unit (near the power inlet), you might be able to get away with a US to EU adapter plug. When in doubt, get a transformer.
If it's a recent synth, check the back of the unit to see if it accepts 110V/60Hz. Most recent electronic devices will accept a range of voltages from 100V to 240V without hassle, but IT SHOULD BE MARKED ON THE UNIT. (Putting this in caps to make sure you check )
If it's an older unit (pre-1990s), go for the transformer option. If it's a more recent unit, check the voltage rating sticker on the unit (near the power inlet), you might be able to get away with a US to EU adapter plug. When in doubt, get a transformer.
Please be positive and constructive with your questions and comments.