RMA request for defective SD adapter

Forum Administrative - NOT PROJECT OR "HELP"

Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.
Locked
User avatar
mo.nyc
 
Posts: 3
Joined: Sat Dec 28, 2013 8:29 pm

RMA request for defective SD adapter

Post by mo.nyc »

Received the shipment promptly and well packaged, and was eager to start.

To my dismay, when plugged in, I could not get a signal from either the RCA or HDMI. Long story short, after diagnosing the issue, it turned out to be a defective microSD adapter -not the SD card itself. I verified this with the microSD adapter I use for my car.

What are the chances of having this minor part replaced?

User avatar
adafruit_support_bill
 
Posts: 88096
Joined: Sat Feb 07, 2009 10:11 am

Re: RMA request for defective SD adapter

Post by adafruit_support_bill »

Please post photos showing all of your soldering and connection to the micro-SD adapter.

User avatar
mo.nyc
 
Posts: 3
Joined: Sat Dec 28, 2013 8:29 pm

Re: RMA request for defective SD adapter

Post by mo.nyc »

adafruit_support_bill wrote:Please post photos showing all of your soldering and connection to the micro-SD adapter.
I mean the micro-SD to standard SD adapter that comes with the pre-installed micro-SD card. Image
Last edited by mo.nyc on Fri Jan 03, 2014 3:40 am, edited 1 time in total.

User avatar
adafruit_support_bill
 
Posts: 88096
Joined: Sat Feb 07, 2009 10:11 am

Re: RMA request for defective SD adapter

Post by adafruit_support_bill »

If you contact [email protected] with a link to this thread we will replace the adapter.

What exactly is the issue with the hub? 2A should be sufficient for 3-4 ASIC Block Erupters.

User avatar
mo.nyc
 
Posts: 3
Joined: Sat Dec 28, 2013 8:29 pm

Re: RMA request for defective SD adapter

Post by mo.nyc »

adafruit_support_bill wrote:If you contact [email protected] with a link to this thread we will replace the adapter.

What exactly is the issue with the hub? 2A should be sufficient for 3-4 ASIC Block Erupters.
I was using a cfminer that was doing a weird thing with the units draining power from other units. Used bfgminer instead and its been fine. Should have updated earlier.

Locked
Please be positive and constructive with your questions and comments.

Return to “Administrative (closed)”