https://www.adafruit.com/products/1901
The sticky stuff sticks to the inside of the little bag, so I bent the wires a little while trying to remove it. Maybe wrapping it in some thin plastic would help.
No damage, but if it was stuck more or if I pulled harder there might have been.
(Also you don't have a pic of exactly where the wires are soldered - I assume to the two outer pads of the three at the bottom center, one says V4+ and one GND - it would be easier with a picture of the wires soldered; the video helps a little)
Qi Charger sticks in baggie.
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- adafruit_support_rick
- Posts: 35092
- Joined: Tue Mar 15, 2011 11:42 am
Re: Qi Charger sticks in baggie.
Thanks for the note. I'll pass it along to the product team.
- sirkha
- Posts: 17
- Joined: Wed Jan 22, 2014 7:18 am
Re: Qi Charger sticks in baggie.
I can confirm that this is still happening on several of the 5 I bought today. I am very worried about damaging the copper coil trying to get it out of the bag.
- adafruit2
- Posts: 22148
- Joined: Fri Mar 11, 2005 7:36 pm
Re: Qi Charger sticks in baggie.
thanks for the note - you can also just cut the bag and then peel it off :)
Please be positive and constructive with your questions and comments.