Qi Charger sticks in baggie.

Forum Administrative - NOT PROJECT OR "HELP"

Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.
Locked
User avatar
tz1
 
Posts: 32
Joined: Sat Aug 01, 2009 11:26 pm

Qi Charger sticks in baggie.

Post by tz1 »

https://www.adafruit.com/products/1901
The sticky stuff sticks to the inside of the little bag, so I bent the wires a little while trying to remove it. Maybe wrapping it in some thin plastic would help.
No damage, but if it was stuck more or if I pulled harder there might have been.
(Also you don't have a pic of exactly where the wires are soldered - I assume to the two outer pads of the three at the bottom center, one says V4+ and one GND - it would be easier with a picture of the wires soldered; the video helps a little)

User avatar
adafruit_support_rick
 
Posts: 35092
Joined: Tue Mar 15, 2011 11:42 am

Re: Qi Charger sticks in baggie.

Post by adafruit_support_rick »

Thanks for the note. I'll pass it along to the product team.

User avatar
sirkha
 
Posts: 17
Joined: Wed Jan 22, 2014 7:18 am

Re: Qi Charger sticks in baggie.

Post by sirkha »

I can confirm that this is still happening on several of the 5 I bought today. I am very worried about damaging the copper coil trying to get it out of the bag.

User avatar
adafruit2
 
Posts: 22148
Joined: Fri Mar 11, 2005 7:36 pm

Re: Qi Charger sticks in baggie.

Post by adafruit2 »

thanks for the note - you can also just cut the bag and then peel it off :)

Locked
Please be positive and constructive with your questions and comments.

Return to “Administrative (closed)”