I recently purchased one of your XBee USB Adapter Boards.
I think it would be easier to solder on the sockets (which came already installed) after the headers (which came loose.) I am not a soldering expert, but I consider myself very capable and I found it difficult, even with a small tip, to solder the headers because of the tight space between the sockets and several of the capacitors and resistors.
I sent this suggestion to Parallax, but since you probably purchase mass quantities, you might have more influence.
XBee USB Adapter Board
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- adafruit_support_bill
- Posts: 88087
- Joined: Sat Feb 07, 2009 10:11 am
Re: XBee USB Adapter Board
Thanks for the suggestion. I can forward this to the products team.
Please be positive and constructive with your questions and comments.