I've made my Mini POV v3.
all route've been checked twice, all connected.
But when it turn on, LED 1 and 5 dimmed. Is there OK?
And I couldn't connect to serial port.
Any suggestion? what should I do?
Is there any differences between ATtiny2313V-10PU and ATtiny2313V-20PU?
I really need help. Any suggestion would be appreciated.
Rgds,
Anjang
About my MiniPOV, need suggestion pls
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
-
- Posts: 1645
- Joined: Sat Nov 10, 2007 12:59 am
Re: About my MiniPOV, need suggestion pls
bad solder joints or wrong resistors. do the other six leds come fully on?Anjang wrote:But when it turn on, LED 1 and 5 dimmed. Is there OK?
bad solder joints or wrong resistors. diode orientation. host configuration.And I couldn't connect to serial port.
not as far as the minipov3 is concerned.Is there any differences between ATtiny2313V-10PU and ATtiny2313V-20PU?
it sounds as though you may have scratch built your minipov. if the chip is not yet programmed and leds 1 and 5 are coming on dimly, there is something seriously wrong with your wiring.
-
- Posts: 2
- Joined: Tue May 26, 2009 5:25 am
Re: About my MiniPOV, need suggestion pls
No. the other six is off, btw, i used 47 Ohm resistors for the LED. Not 100 Ohm.mtbf0 wrote:bad solder joints or wrong resistors. do the other six leds come fully on?Anjang wrote:But when it turn on, LED 1 and 5 dimmed. Is there OK?
I've double check all connection. And i'll do it again.mtbf0 wrote:bad solder joints or wrong resistors. diode orientation. host configuration.Anjang wrote:And I couldn't connect to serial port.
Thanks 'cos i used 20PU for the MiniPOV not 10PU.mtbf0 wrote:not as far as the minipov3 is concernedAnjang wrote:Is there any differences between ATtiny2313V-10PU and ATtiny2313V-20PU?
That's exactly what i want to find out.it sounds as though you may have scratch built your minipov. if the chip is not yet programmed and leds 1 and 5 are coming on dimly, there is something seriously wrong with your wiring.
Any other suggestion
Please be positive and constructive with your questions and comments.