I have t o swing it so fast its not even funny to see anything at all? Im not sure what Im doing wrong?
Mini POV 3 KIT directly to serial port,
my last update looked like:
Code: Select all
C:\>make program-minipov
avrdude -p attiny2313 -P com2 -c dasa -U flash:w:minipov.hex
avrdude: AVR device initialized and ready to accept instructions
Reading | ################################################## | 100% 0.02s
avrdude: Device signature = 0x1e910a
avrdude: NOTE: FLASH memory has been specified, an erase cycle will be perform
To disable this feature, specify the -D option.
avrdude: erasing chip
avrdude: reading input file "minipov.hex"
avrdude: input file minipov.hex auto detected as Intel Hex
avrdude: writing flash (336 bytes):
Writing | ################################################## | 100% 0.50s
avrdude: 336 bytes of flash written
avrdude: verifying flash memory against minipov.hex:
avrdude: load data flash data from input file minipov.hex:
avrdude: input file minipov.hex auto detected as Intel Hex
avrdude: input file minipov.hex contains 336 bytes
avrdude: reading on-chip flash data:
Reading | ################################################## | 100% 0.45s
avrdude: verifying ...
avrdude: 336 bytes of flash verified
avrdude: safemode: Fuses OK
avrdude done. Thank you.
C:\>