No Square Wave VCO output
Moderators: Altitude, adafruit_support_bill, adafruit, phono, mome rath

No Square Wave VCO output

by mjc76 on Mon Oct 08, 2012 10:12 am

Just completed building my first X0Xbox. The saw output works just fine but the square wave is very faint. I went back through and checked everything on the board and it all looks fine. Any ideas?
mjc76
 
Posts: 4
Joined: Mon Oct 08, 2012 10:10 am

Re: No Square Wave VCO output

by mjc76 on Fri Oct 19, 2012 9:28 pm

Can anyone tell me the voltages out of Q8? Actually all of the voltages for the VCO would be helpful. Thanks.
mjc76
 
Posts: 4
Joined: Mon Oct 08, 2012 10:10 am

Re: No Square Wave VCO output

by MMM on Sat Oct 20, 2012 3:10 am

MMM
 
Posts: 431
Joined: Tue Apr 24, 2012 12:51 am

Re: No Square Wave VCO output

by mjc76 on Sun Oct 21, 2012 8:24 pm

Ok. So i checked my VCO output voltages. 8.16 for saw and 6.86 for square. I can put a headphone up to the output of the waveform switch and clearly hear the square wave. But it is very, very faint out of the headphone or line out. The saw has plenty of volume though.
mjc76
 
Posts: 4
Joined: Mon Oct 08, 2012 10:10 am

Re: No Square Wave VCO output

by mjc76 on Wed Oct 24, 2012 9:16 am

Does anyone have anything like this for the VCO section? Thanks.

Image
mjc76
 
Posts: 4
Joined: Mon Oct 08, 2012 10:10 am