I know there has been talk on the site regarding soft scopes-
Could someone recommend one or look at this one and recommend how to adjust the settings (http://www.virtins.com/) in order to run tests during the build process-?
Specificly the
T=
A=
B=
Also, do you ground the sleeve wire to the ground on the power supply board and probe with the tip wire?
Thank you very much-
Software Scope settings
Moderators: altitude, adafruit_support_bill, adafruit, phono, hamburgers
Please be positive and constructive with your questions and comments.
-
- Posts: 142
- Joined: Thu Jun 02, 2005 12:28 pm
-
- Posts: 77
- Joined: Wed May 25, 2005 12:33 am
Please be positive and constructive with your questions and comments.