schematic question

Discuss x0x construction and related issues

Moderators: altitude, adafruit_support_bill, adafruit, phono, hamburgers

Please be positive and constructive with your questions and comments.
Locked
User avatar
subatomic
 
Posts: 523
Joined: Wed May 11, 2005 3:12 pm

schematic question

Post by subatomic »

in the rotery encoders section near tempo, it shows R2 and R5 as being 10k.

But R2 and R5 are also in the PSU section, and are not equal to 10k...
So I'm wondering if these two resistors are mislabeled in the schematic.


Another question I have is, I'm waiting for LEDs to arrive, so I want to put in every resistor in the sequencer except for the ones for the LEDs. For the 10k's very near the tempo encoder, which resistors are needed? I see 3 slots (R234, 269, 270).
Assuming at least one of those is for the tempo LED... I got confused by the R2/R5 in the schematic. and I can't seem to identify where those resistors are in the schematic since it's really really tight in the LED section.

Also, it would be really useful to have a png of the circuit board online so I can look at traces that have been covered up by soldered in pots and other components. My problem with the resistors above could be solved by knowing where the wires are running... but I can't see them for the tempo knob on top of them.

thanks,

Locked
Please be positive and constructive with your questions and comments.

Return to “Making x0x”