Hi there
I digged the forum many times and could not finally found clear STEP BY STEP manual how to update a firmware at x0xb0x for WIN and MAC.
Could please someone make it?
It would be very usefull - with links to software parts, with links to additional pythons and other snakes if needed!
Sorry to asking in XXXth time, there are many topics but no clear and useful one (for n00b and dummy as i am).
thank you
SOFTWARE UPDATE QUESTION #...
Moderators: altitude, adafruit_support_bill, adafruit, phono, hamburgers
Please be positive and constructive with your questions and comments.
-
- Posts: 27
- Joined: Mon Jun 29, 2009 5:51 am
Re: SOFTWARE UPDATE QUESTION #...
Here is a short one from me for Mac :
I finally did it....
I am using a (old) Mac G4 MP with OS 10.4.11...and downloaded the following progs (tx for the hints Toxaco) :
Python 2.5.4 (Standard install.)
wxpython (Standard install.)
pyserial (Extract files from the archive, open a shell/console in that directory and type: "python setup.py install")
USB Serial Driver : FT232B 2.1.10 (Standard install.)
c0ntr0l for Mac (Just unzip)
After installing everything just be sure to restart the Mac once, then doubleclick c0ntr0l.py and follow the standard procedure to update the firmware of the x0xb0x.
I finally did it....
I am using a (old) Mac G4 MP with OS 10.4.11...and downloaded the following progs (tx for the hints Toxaco) :
Python 2.5.4 (Standard install.)
wxpython (Standard install.)
pyserial (Extract files from the archive, open a shell/console in that directory and type: "python setup.py install")
USB Serial Driver : FT232B 2.1.10 (Standard install.)
c0ntr0l for Mac (Just unzip)
After installing everything just be sure to restart the Mac once, then doubleclick c0ntr0l.py and follow the standard procedure to update the firmware of the x0xb0x.
Please be positive and constructive with your questions and comments.