No charge... :(
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
-
- Posts: 2
- Joined: Fri May 04, 2007 6:02 pm
No charge... :(
So when I finished I tested it (with an old ipod that holds a charge for about a minute) and it worked, plugged into ipod video, worked, got case ready went for 1 more test.... didn't work... what happened, I soldered it a little more on each piece. Still NOTHING! Please HELP!
-
- Posts: 2
- Joined: Fri May 04, 2007 6:02 pm
-
- Posts: 12151
- Joined: Thu Apr 06, 2006 4:21 pm
DC Voltage, 20V if it has multiple ranges.
http://www.ladyada.net/make/mintyboost/make.html
has a video on how to use multimeters.
however, theres a pretty good chance that when putting it into the case you shorted out some pins on the tin (they were not cut short enough, or the foam tape wasnt attached well, and fried the MAX756 chip.
http://www.ladyada.net/make/mintyboost/make.html
has a video on how to use multimeters.
however, theres a pretty good chance that when putting it into the case you shorted out some pins on the tin (they were not cut short enough, or the foam tape wasnt attached well, and fried the MAX756 chip.
Please be positive and constructive with your questions and comments.