I just built my mintyboost and it's testing 7.7 output instead of the expected 5. Any ideas about what might be causing the problems?
I know it looks crappy. the problem was that my soldering iron crapped out on me at the start of the lab and didn't figure it out until later. I got a new one and retouched everything up.. It doesn't look as bad as these high-res pics x(
http://i10.photobucket.com/albums/a142/ ... C_0042.jpg
http://i10.photobucket.com/albums/a142/ ... C_0043.jpg
Any help would be really appreciated, I'm trying to make one as a gift as well = (
Output 7.7 V?
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
Please be positive and constructive with your questions and comments.