Edit: I had an 8 pin EEPROM chip laying around and put that in instead of the MAX. That was sure stupid! After putting the MAX756 in, I get 5V exactly. Beautiful.
I have a problem-- My output voltage is only 3V...which equals the two new batteries I put in.
I've been trying to figure this out for 3 hours now-- nothing from the forums (or my darn brain) has worked. Assembly seemed to go okay, I installed R5 in the "pullup" configuration and followed everything to the letter.
I've tested continuity between a bunch of points and scraped between some joints to make sure there wasn't a tiny short. Is that brown flux stuff conductive?
Any help is much appreciated...
Update: nevermind, I'm an idiot... was: battery V = output V
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
-
- Posts: 1
- Joined: Sat Sep 22, 2007 4:31 pm
Update: nevermind, I'm an idiot... was: battery V = output V
Last edited by newGuy on Fri May 22, 2009 2:03 pm, edited 1 time in total.
Please be positive and constructive with your questions and comments.