PLL for RF freq 1200MHz & prescaler 8: B=150 A=BANNED

The operation of transmitters designed to jam or block wireless communications is a violation of the Communications Act of 1934, as amended ("Act"). See 47 U.S.C. Sections 301, 302a, 333. The Act prohibits any person from willfully or maliciously interfering with the radio communications of any station licensed or authorized under the Act or operated by the U.S. government. 47 U.S.C. Section 333. The manufacture, importation, sale or offer for sale, including advertising, of devices designed to block or jam wireless transmissions is prohibited. 47 U.S.C. Section 302a(b). Parties in violation of these provisions may be subject to the penalties set out in 47 U.S.C. Sections 501-510. Fines for a first offense can range as high as $11,000 for each violation or imprisonment for up to one year, and the device used may also be seized and forfeited to the U.S. government.

Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.
Locked
Wrhector
 
Posts: 16
Joined: Wed Apr 22, 2009 2:18 pm

PLL for RF freq 1200MHz & prescaler 8: B=150 A=BANNED

Post by Wrhector »

I have just finished the PLL stage and programmed the full code. When it runs with the com port view I get

I HCIiÛ3Wavebubble v1.0
PLL for RF freq 1200MHz & prescaler 8: B=150 A=BANNED

And the two's continue. Also there is a clicking noise from the board.

Pressing space bar during or straight after start up gives no effect.

Anybody have any ideas of what could be wrong?

Thanks

Wrhector
 
Posts: 16
Joined: Wed Apr 22, 2009 2:18 pm

Re: PLL for RF freq 1200MHz & prescaler 8: B=150 A=BANNED

Post by Wrhector »

I was checing soldering joints and it fixed its self....

I Get:
RF VCO range is too low!
have to do some tweaking...

Locked
Please be positive and constructive with your questions and comments.

Return to “Wave Bubble”