LED1 orientation LiIon Board

The operation of transmitters designed to jam or block wireless communications is a violation of the Communications Act of 1934, as amended ("Act"). See 47 U.S.C. Sections 301, 302a, 333. The Act prohibits any person from willfully or maliciously interfering with the radio communications of any station licensed or authorized under the Act or operated by the U.S. government. 47 U.S.C. Section 333. The manufacture, importation, sale or offer for sale, including advertising, of devices designed to block or jam wireless transmissions is prohibited. 47 U.S.C. Section 302a(b). Parties in violation of these provisions may be subject to the penalties set out in 47 U.S.C. Sections 501-510. Fines for a first offense can range as high as $11,000 for each violation or imprisonment for up to one year, and the device used may also be seized and forfeited to the U.S. government.

Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.
Locked
digitaladdictions
 
Posts: 15
Joined: Tue Nov 24, 2009 4:44 pm

LED1 orientation LiIon Board

Post by digitaladdictions »

Sorry if I am missing some obvious piece of documentation here. I just started assembling my wave bubble, starting with the liIon battery board and cannot find a component layout document anywhere showing the orientation of the components. I was able to get most of the orientations using the silkscreen layer in the eagle files but the orientation for LED1 eludes me.

I have the component layout diagrams for the main board but not the battery board. Maybe Im blind but Im not seeing anything to do with the battery board in the schematic either.

On a side note after attaching the FT232RL with relative ease I am feeling much more confident about the successful completion of this project. Im all about solder paste now.

digitaladdictions
 
Posts: 15
Joined: Tue Nov 24, 2009 4:44 pm

Re: LED1 orientation LiIon Board

Post by digitaladdictions »

Never mind I was being an idiot (as I suspected). I was looking at cigpack-batt_lm3622.brd and seeing LED1 right next to C4 and thinking C4 was the pad for LED1.

Locked
Please be positive and constructive with your questions and comments.

Return to “Wave Bubble”