Re: Wave Bubble 2010
Close to being done with the main board in eagle. I have 98 more DRC errors to check. as an FYI, there will be close to 200-250 'approved" errors, things such as vias touching other ground pads (they are both ground so it doesn't matter), etc. I am using SparkFun/BatchPCB's rules, which are much less generous than other board houses. For example, BatchPCB has a 8mil trace/spacing limit, and 20mil holes, other places can go much smaller. So since the boards pass BatchPCB's tests, they should work for any board house. I should be done cleaning up and checking by sunday.
Attached are two sets of eagle files. One is with the original sized Outline from the import. There is a downside to this and that is that with the switches mictronics picked, they barely fit to the edges (definitely don't go over). The second set is with the boarder shrunk in slightly so that the push button hangs over slightly.
The board is untested so far, I have verified the battery board I posted before works, but so far have not finished building this, so for now, use at your own risk. I would highly encourage anyone wanting to use these to open in Eagle and check for yourself before using, until I am able to finish building.
- Main Board Big Outline.zip
- Eagle files for Main board with bigger outline
- (71.34 KiB) Downloaded 308 times
- SparkFun Rules.zip
- Sparkfun rules used for DRC
- (847 Bytes) Downloaded 266 times
- Main Board Small Outline.zip
- Eagle files for Main board with smaller outline
- (71.7 KiB) Downloaded 274 times