As I program pcb???????? Help!!!!!!!!!!!!!

The operation of transmitters designed to jam or block wireless communications is a violation of the Communications Act of 1934, as amended ("Act"). See 47 U.S.C. Sections 301, 302a, 333. The Act prohibits any person from willfully or maliciously interfering with the radio communications of any station licensed or authorized under the Act or operated by the U.S. government. 47 U.S.C. Section 333. The manufacture, importation, sale or offer for sale, including advertising, of devices designed to block or jam wireless transmissions is prohibited. 47 U.S.C. Section 302a(b). Parties in violation of these provisions may be subject to the penalties set out in 47 U.S.C. Sections 501-510. Fines for a first offense can range as high as $11,000 for each violation or imprisonment for up to one year, and the device used may also be seized and forfeited to the U.S. government.

Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.
Locked
krader
 
Posts: 2
Joined: Tue Jan 09, 2007 6:19 pm

As I program pcb???????? Help!!!!!!!!!!!!!

Post by krader »

I have a doubt. I not like programming the pcb.I try to compile the .c and .h files but the AVR Studio gives error. As I can I to obtain .hex file to program micro?. Or it is not necessary?. Later, I connect pcb to usb and with the SecureCRT I write "test_uart()" directly?. And later??
Please, to explain it step by step
Please, to help me. I have bought the material and not like programming it.

Thank you very much.

Locked
Please be positive and constructive with your questions and comments.

Return to “Wave Bubble”