The operation of transmitters designed to jam or block wireless communications is a violation of the Communications Act of 1934, as amended ("Act"). See 47 U.S.C. Sections 301, 302a, 333. The Act prohibits any person from willfully or maliciously interfering with the radio communications of any station licensed or authorized under the Act or operated by the U.S. government. 47 U.S.C. Section 333. The manufacture, importation, sale or offer for sale, including advertising, of devices designed to block or jam wireless transmissions is prohibited. 47 U.S.C. Section 302a(b). Parties in violation of these provisions may be subject to the penalties set out in 47 U.S.C. Sections 501-510. Fines for a first offense can range as high as $11,000 for each violation or imprisonment for up to one year, and the device used may also be seized and forfeited to the U.S. government.
I am an electonics rookie and i would like to build the wave bubble. I dont know how bad this sounds but i had problems interpreting the circuit diagram most especially the noise generator where in does it connect to. it just seems to be sitting on its on in that corner.
Try opening the BRD and SCH files from the wave bubble download section in a free version of eaglecad downloadable at the official website. This will tell you how the components in the diagrams are connected.
I have gone through the schema & the board and there seems to be some disperity between the 2. Like there is no C30 in the schematic. Also on the board d4 has no connection at the other end its just connected to R16