Re: Please change the silkscreening on the spokepov ver 1.1
I did the exact same thing with my SpokePOV. Unfortunately I soldered according to the silkscreen and not the written instructions. After all sixty LEDs were soldered, I powered up the board and found no lights. I could connect the SpokePOV via USBtiny and download the pre-loaded images. I tested for voltage on the LED and found that it was getting good voltage.
Here's the kicker, the issue though is not the silkscreen, but with the LED itself. Normally the flat side of the LED is the cathode (short) side but the ones I received have the flat side on the anode (long) side so if you match the silkscreen, they will be backwards. This means the long lead is on the inside of the board. I have the red LED kit.
I'm wondering if that's the reason why so many people are mixing it up.
Anyways, I have a crazy amount of desolder and resoldering as well. Is there any way that I can get a replacement as well. I received the order as a gift, but can get their information.