After lack of success programming my spoke pov with my parts, I ordered a kit with parts. I dropped the sent cpu I received onto the board with my parts and everything works. So, I think my board is good, and my ATTINY isn't programmed right.
My part will test run through all the leds at a slower rate than the part I received. That is, if I change the delay in main.cc:test_led from 50 to 10, my part and the mailed part runs through those leds on a hard reset at the same rate. Are the cpus mailed programmed with the exact same code available at the spoke POV's download page?
Is V1.01 the mailed firmware?
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
Please be positive and constructive with your questions and comments.