I seen the video today on lazor cut sheet stencil and wonder... has anyone tried here the inject solder paste with the blunt tip syringe needle?
What paste works good and what tips because I don't have a cnc or lazor cutter to make stencils yet mylar and exacto maby...
This set was mentioned on rep rap and would like advice before I build the 3 motor driver 2.3 boards I got from makerbot.
http://www.reprap.org/bin/view/Main/SMTSolderingToolKit
Here are the motor drivers I bought for a 3 axis linux cnc machine controled by the printer port... too bad the motor driver board doen't have the same I and O to do this but it is better for what it is for. It doen't match with my newbie ness to linux cnc.
http://www.reprap.org/bin/view/Main/Ste ... Driver_2_3
I seen the video today on lazor cut sheet stencil and wonder
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
-
- Posts: 213
- Joined: Wed Jan 16, 2008 8:38 am
Please be positive and constructive with your questions and comments.