Laser cutting holes in project boxes?
Moderators: adafruit_support_bill, adafruit

Laser cutting holes in project boxes?

by mikeselectricstuff on Thu Sep 23, 2010 12:24 pm

How good are cheapo (40W) cutters at cutting holes in ABS, as used for most cheap project boxes from Hammond etc.?
mikeselectricstuff
 
Posts: 164
Joined: Fri Jun 11, 2010 8:21 pm

Re: Laser cutting holes in project boxes?

by Philly on Thu Sep 23, 2010 1:39 pm

As long as its no thicker than 2-3mm it should cut ok although we noticed that with dodgy acrylic it would leave a dodgy edge.

Here is a cheap chinese job in action: http://www.youtube.com/watch?v=StN3RwXZ ... re=related
Philly
 
Posts: 57
Joined: Sun Jun 20, 2010 6:53 am