>2D

Share your information, hints and discuss Laser cutters/engravers

Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.
Locked
User avatar
rektide
 
Posts: 3
Joined: Thu Oct 21, 2010 12:17 am

>2D

Post by rektide »

Greater than 2D. (Also a cool emoticon.)

I'm wondering if anyone else has interests in a laser cutter with >2 degrees of freedom. My current plans are to build a reprap, then design and build a head to one dimensionally control the angle of impact of a 20-50 watt optically coupled LED laser diode. Given that I dont even know what electronics the reprap is actually going to run, and that I havent begun designing the low voltage supply for the diode, this is all a bit off, but I wanted to throw this post up, and gather what info there is.

Someone designed a laser cutting head for the reprap, and has a video of it on youtube. This design has a rotating head, which at the moment I dont foresee myself needing. It seems to have manual angle of incidence adjustment, which perhaps might be automate-able with good results. Anyways, cool project, check out the video.
http://www.youtube.com/watch?v=V1Idxz5VNgI

Matt

Locked
Please be positive and constructive with your questions and comments.

Return to “Laser”