LaserU
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- ak chris
- Posts: 15
- Joined: Mon Jun 02, 2008 3:06 pm
I'd say save your money and check out the Saw Mill Creek Laser Forum at www.sawmillcreek.org. There is a ton of info in the archives and everyone on there is knowledgeable and very willing to share info, sources, etc. Reps from both Epilog and Universal frequent the site as well.
I'm basing this on the positive experience I've had lurking and occasionally posting at Saw Mill and it isn't intended to be a knock on Laser U. I have no experience with it other than briefly checking it out. I'd rather sink my hard earned dinero in equipment and supplies any chance I get!
Chris
I'm basing this on the positive experience I've had lurking and occasionally posting at Saw Mill and it isn't intended to be a knock on Laser U. I have no experience with it other than briefly checking it out. I'd rather sink my hard earned dinero in equipment and supplies any chance I get!
Chris
Please be positive and constructive with your questions and comments.