Fingerprint Module with extra cover layer

[mbn12]

Hello guys,

I would like to build a project using the fingerprint sensor from Adafruit ( ID 751 ) and mount it behind a thin layer of glass.

Could someone who has this module and a spare piece of acrylic or glass (1 - 3 mm) please test if this work?

The extra layer, being fully transparent, shouldn't affect the lightning. But I don't know if there's something about image focus, regarding what the sensor was calibrated, or something like that.

Thank you,

Mario

[adafruit_support_bill]

No, this won't work. The the finger must be in direct contact with the glass.

[mbn12]

Too bad... :/

Thanks for the reply.

If someone knows a module that allows this, please post here. This would enable some pretty nice case designs.

Thanks