Hi,
Didn't find a forum section that would apply to my question.
Does anybody have a caliper and the "Slotted Aluminum Extrusion - 20mm x 20mm"
Product ID: 1221
I would need the diameter of the hole in the center of the extrusion, in inch or millimeter
I have a project that would require me to tap that hole.
Regards,
Louis Raymond
Aluminium Extrusion
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- jepler
- Posts: 10
- Joined: Wed May 08, 2013 12:47 pm
Re: Aluminium Extrusion
Hi Louis,
The approximate diameter is 4.45mm / 0.17"
Hope this helps!
The approximate diameter is 4.45mm / 0.17"
Hope this helps!
-
- Posts: 3
- Joined: Tue Jul 09, 2013 8:40 pm
Re: Aluminium Extrusion
Does the 20 mm x 20 mm aluminum extrusion listed on the adafruit site have the same dimensional cross-section as 80/20 or Misumi 20x20 products? Will the adafruit fasteners and braces work with other brands?
Please be positive and constructive with your questions and comments.