Quick questions -
1. is it possible to order the lipo charger without the JST connector and just indications of pinout for + / - instead?
2. is it possible to remove the original jst connector for the ones I already bought (I want to solder directly and maintain a lower overall profile)
Thanks
Jst connector on PCB Lipo Charger
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- adafruit_support_bill
- Posts: 88093
- Joined: Sat Feb 07, 2009 10:11 am
Re: Jst connector on PCB Lipo Charger
It is not difficult to remove these from the board. Just heat the solder joints and gently lift the connector free.
- adafruit_support_rick
- Posts: 35092
- Joined: Tue Mar 15, 2011 11:42 am
Re: Jst connector on PCB Lipo Charger
Which charger are you referring to? - we have several
-
- Posts: 2
- Joined: Fri Sep 20, 2013 3:35 pm
Re: Jst connector on PCB Lipo Charger
id 1304 / v1
http://www.adafruit.com/products/1304
This one. I suspect there are four solder points. Just needed to confirm before doing anything stupid.
Thanks.
http://www.adafruit.com/products/1304
This one. I suspect there are four solder points. Just needed to confirm before doing anything stupid.
Thanks.
- adafruit_support_bill
- Posts: 88093
- Joined: Sat Feb 07, 2009 10:11 am
Re: Jst connector on PCB Lipo Charger
I'm pretty sure there are only 2 solder points on that one. 2 pin devices are easy to remove.
Please be positive and constructive with your questions and comments.