Mechanical drawing for GA1A12S202 light sensor

Breakout boards, sensors, other Adafruit kits, etc.

Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.
Locked
User avatar
fll_freak
 
Posts: 1
Joined: Sat Dec 14, 2013 6:53 pm

Mechanical drawing for GA1A12S202 light sensor

Post by fll_freak »

I am building a light sensor system using the GA1A12S202 breakout board. The design is documents at http://www.fll-freak.com/blog.

I have the ability to 3D print a holder for the sensor as well as the filter and optical parts. Although I can use a dial caliper to get the critical dimensions of the board outline and location of critical parts, it would be much nicer to get the mechanical design files directly. Any chance of that?

User avatar
adafruit_support_mike
 
Posts: 67446
Joined: Thu Feb 11, 2010 2:51 pm

Re: Mechanical drawing for GA1A12S202 light sensor

Post by adafruit_support_mike »

I don't see the EAGLE files on Github, but the product page gives the basic dimensions: 10mm wide, 13mm high, 1.5mm deep.

The pin headers are on 0.1" centers centered across the width, 0.05" in from the edge of the board. There's a 0.1" mounting hole centered across the top, 0.1" in from the edge.

Locked
Please be positive and constructive with your questions and comments.

Return to “Other Products from Adafruit”