This project is running on a Raspi. B 512MB normal mode
The BMP180 is connected exactly as follows to a PermaProto 1/2 size board :
VIN to 3v3, GND to GND, SDA to SDA and SCL to SCL (no surprises there)
The breakout board is connected with a brand new GPIO connector to the back of a 2.8" tft screen
Both i2c-tools and python-smbus are properly installed and the Github code adapted to BMP085
has been downloaded and modified using the smbus 1 (removed the blacklisting as well in modprobe.d folder configuration file)
All these were double checked..
The wall is that when i am running
Code: Select all
sudo i2c-detect -y 1
I would appreciate some insight into the matter