Hello,
I have the arduino, then a motor shield that comes pinned, and then mounted the tft 2.8 shield.
I need, as show in the picture, a way to put cables connected to several pins,in this example to get 5V and ground from motor shield, but on the other side i want to connect 5 buttons so to inputs 1-4.
Problem is that im a newbie on soldering and i dont want to crash the pieces or try & learning during weeks,
I think matybe are some kind of cable that allows me or help me to put cables from breadboard to between the shield, how ? alternative ?
Cable or something to avoid solder on shield pins
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
-
- Posts: 74
- Joined: Thu Feb 20, 2014 5:36 pm
- adafruit_support_bill
- Posts: 88154
- Joined: Sat Feb 07, 2009 10:11 am
Re: Cable or something to avoid solder on shield pins
The wing shield is the best way to get access to pins between shields: http://www.adafruit.com/products/196
-
- Posts: 74
- Joined: Thu Feb 20, 2014 5:36 pm
Re: Cable or something to avoid solder on shield pins
Question, how much increase the size (height) ?
The middle photos i dont understand whats on top, a same piece of the proto-shield or another component not from that for show purspose ?
But, heyy it comes unsoldered ?
if so, do not solve my problem cause i dont know how to solder and i dont want to spend time with soldering techniques, Could you send me that soldered, like the 2.8 tft shield (annd not like adafruit motor shield) ?
The middle photos i dont understand whats on top, a same piece of the proto-shield or another component not from that for show purspose ?
But, heyy it comes unsoldered ?
if so, do not solve my problem cause i dont know how to solder and i dont want to spend time with soldering techniques, Could you send me that soldered, like the 2.8 tft shield (annd not like adafruit motor shield) ?
- adafruit_support_bill
- Posts: 88154
- Joined: Sat Feb 07, 2009 10:11 am
Re: Cable or something to avoid solder on shield pins
The Wing shield will increase the stack height by approximately 12mm.
The middle photo shows the wing shield on top of an Arduino Uno.
We do not sell these pre-assembled.
The middle photo shows the wing shield on top of an Arduino Uno.
We do not sell these pre-assembled.
Please be positive and constructive with your questions and comments.