Hi,
I have found that pins 2 and 3 (D- and D+) are the wrong way around in Device: USBTHM (USB) Package: USB-MINIB-THM
They are listed as pin 2 D+ and pin 3 D-, when it should be pin 2 D- and pin 3 D+.
I figured this out after quite some time trying to figure out why my board would not work at all, and I confirmed this at against USB pinouts for the actual part itself.
I swapped my wiring around and it now works fine.
Cheers
Douglas
Possible pinout error in your Eagle Library for Device: USBT
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- snuffles
- Posts: 1
- Joined: Sat Aug 16, 2014 2:02 am
- adafruit_support_rick
- Posts: 35092
- Joined: Tue Mar 15, 2011 11:42 am
Re: Possible pinout error in your Eagle Library for Device:
Thanks! I'll check it out...
- adafruit2
- Posts: 22148
- Joined: Fri Mar 11, 2005 7:36 pm
Re: Possible pinout error in your Eagle Library for Device:
thanks for the note, we added this to the issue list, when we do a clean up of the library (which is much needed and will hopefully occur soon!) we'll tidy this up
Please be positive and constructive with your questions and comments.