OK It's CRUNCH TIME! My Moonlight Madness ride is tomorrow night. Rear SpokePOV is installed and ROCKING!! Front wheel - not so much. It powers up just fine, but I can't connect to the AVR programmer. Gives me the Port not found errors. I have no problem connecting to my other SpokePOV. I put on my glasses & a new tip on the soldering iron and got to work. Saw some weak solders that I took care of, and ended up replacing the 8 pin socket for the IC. Still same problem. I've checked and rechecked my solders - everything APPEARS fine. When I attepmt to connect the red led on the avr programmer lights for a split second then they both go out before the error message pops up in windows (XP). When I plug and unplug the 10 pin connector I've noticed that the led's react - different ones lighting up as I plug and unplug. I've checked and rechecked the solders on the 10 pin socket and they seem fine. I have not swapped ic's from my other SpokePOV, but that's next! Any other suggestions?