Hi there. Just had some final questions before jumping into programming my chips.
I am looking to use my usbtiny with a minimalist board to program my attiny45 and see that mentioned here, it says to keep the resistors in. However, if I decide in the future to not use a minimalist board when programming my attiny chips, I would have to replace R4 and R7 with jumpers correct?
Are those 2 resistors necessary when using a min board? I could just install them onto my min board, right (in the SCK and MOSI lines)? That way I don't have to mess with the usbtiny if I decide to use it with something else (other than spokepov) later.
I know the general rule is to remove the resistors when programming, discussed here.
Thanks for the help, still learning.
To resist or not resist.
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- adafruit_support_bill
- Posts: 88088
- Joined: Sat Feb 07, 2009 10:11 am
Re: To resist or not resist.
Question answered in the other thread. Please don't post the same question in multiple threads.
Please be positive and constructive with your questions and comments.