no green light

by stevematt21 on Mon Dec 17, 2012 6:45 pm

Hello ! i have purchased a kit v2.0 and i built it today, tried to use it on my new mac mini, no green light. I read that it has a problem with usb 3.0 ports, so i tried to use it on my dell laptop no luck...

i tested my solder connections with a ohm meter all connections work just fine
stevematt21
 
Posts: 4
Joined: Mon Dec 17, 2012 6:42 pm

Re: no green light

by adafruit_support_bill on Tue Dec 18, 2012 6:18 am

Post photos of the front & back of the board and we will check the assembly.
User avatar
adafruit_support_bill
 
Posts: 28061
Joined: Sat Feb 07, 2009 9:11 am

Re: no green light

by stevematt21 on Tue Dec 18, 2012 10:47 am

here it is
Attachments
back.jpg
back.jpg (471.17 KiB) Viewed 2676 times
front.jpg
front.jpg (445.62 KiB) Viewed 2676 times
stevematt21
 
Posts: 4
Joined: Mon Dec 17, 2012 6:42 pm

Re: no green light

by adafruit_support_bill on Tue Dec 18, 2012 11:53 am

You have many joints that are not completely soldered. Testing them with a meter is not sufficient. Review the soldering guide and re-flow all the joints and add solder as needed.
http://learn.adafruit.com/adafruit-guid ... -soldering
http://learn.adafruit.com/adafruit-guid ... n-problems
User avatar
adafruit_support_bill
 
Posts: 28061
Joined: Sat Feb 07, 2009 9:11 am

Re: no green light

by stevematt21 on Tue Dec 18, 2012 6:12 pm

success! A found new hardware came up now what do i do?
stevematt21
 
Posts: 4
Joined: Mon Dec 17, 2012 6:42 pm

Re: no green light

by stevematt21 on Tue Dec 18, 2012 7:15 pm

Ok found out how to install it, i put the blank atmega 168 in the audrino uno plug the 6 pin cable to the uno from the usbtiny and burn the bootloader this is the error message i get
Attachments
error.png
error.png (99.09 KiB) Viewed 2534 times
stevematt21
 
Posts: 4
Joined: Mon Dec 17, 2012 6:42 pm

Re: no green light

by adafruit_support_bill on Wed Dec 19, 2012 7:12 am

Post a photo showing all your connections.
User avatar
adafruit_support_bill
 
Posts: 28061
Joined: Sat Feb 07, 2009 9:11 am