Hello ! i have purchased a kit v2.0 and i built it today, tried to use it on my new mac mini, no green light. I read that it has a problem with usb 3.0 ports, so i tried to use it on my dell laptop no luck...
i tested my solder connections with a ohm meter all connections work just fine
no green light
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- adafruit_support_bill
- Posts: 88092
- Joined: Sat Feb 07, 2009 10:11 am
Re: no green light
Post photos of the front & back of the board and we will check the assembly.
-
- Posts: 4
- Joined: Mon Dec 17, 2012 7:42 pm
Re: no green light
here it is
- Attachments
-
- back.jpg (471.17 KiB) Viewed 3144 times
-
- front.jpg (445.62 KiB) Viewed 3144 times
- adafruit_support_bill
- Posts: 88092
- Joined: Sat Feb 07, 2009 10:11 am
Re: no green light
You have many joints that are not completely soldered. Testing them with a meter is not sufficient. Review the soldering guide and re-flow all the joints and add solder as needed.
http://learn.adafruit.com/adafruit-guid ... -soldering
http://learn.adafruit.com/adafruit-guid ... n-problems
http://learn.adafruit.com/adafruit-guid ... -soldering
http://learn.adafruit.com/adafruit-guid ... n-problems
-
- Posts: 4
- Joined: Mon Dec 17, 2012 7:42 pm
Re: no green light
success! A found new hardware came up now what do i do?
-
- Posts: 4
- Joined: Mon Dec 17, 2012 7:42 pm
Re: no green light
Ok found out how to install it, i put the blank atmega 168 in the audrino uno plug the 6 pin cable to the uno from the usbtiny and burn the bootloader this is the error message i get
- Attachments
-
- error.png (99.09 KiB) Viewed 3002 times
- adafruit_support_bill
- Posts: 88092
- Joined: Sat Feb 07, 2009 10:11 am
Re: no green light
Post a photo showing all your connections.
Please be positive and constructive with your questions and comments.