Hi, I bought the USBtinyISP Kit v2.0 and I was VERY excited to get it up and running.
While I was soldering it, the micro-controller fell from the table and I had no idea. I went over it again and again with the chair wheels without noticing! it is completely damaged right now!!!
That is the ONLY thing missing to complete this project.
Is there anyway I can buy a ready good to go pre-programmed micro-controller that I can just plug it into the socket?
Thank you,
-Rami
Broken micro-controller ATTINY2313-20PU
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- adafruit_support_rick
- Posts: 35092
- Joined: Tue Mar 15, 2011 11:42 am
-
- Posts: 5
- Joined: Sun May 29, 2011 2:55 am
Re: Broken micro-controller ATTINY2313-20PU
Wow! I cannot believe I missed it! I would have added a couple of them if I had noticed them in the "suggested" section below.
Thank you very much!
-Rami
Thank you very much!
-Rami
Please be positive and constructive with your questions and comments.