by tslg on Thu Jan 24, 2013 11:31 am

Hey there, I'm kind of new to electronics and just got my new flora board.
It works fine but I couldn't find some infos about that little switch and its function.

I looked it up in the scematics but I don't know what it will do, it is labeled as "ON/OFF EG1390" (again I'm new to electronics).
I know the little button is "RESET" for the ATMEGA, but switching the position of the switch does nothing at all.

Thanks for your help and time.
Posts: 1
Joined: Thu Jan 24, 2013 11:18 am

by adafruit_support_bill on Thu Jan 24, 2013 2:07 pm

The two-position switch on the Flora is an on/off switch.
User avatar
Posts: 25331
Joined: Sat Feb 07, 2009 9:11 am

by benhhumphrey on Fri Jan 25, 2013 10:47 am

It's only effective if you're running off of battery power; if you're getting your power through USB, it doesn't do anything.
Posts: 3
Joined: Sun Jan 06, 2013 10:44 pm