Flora GPS Starter Pack: Flora not detected on a mac
I was following the instructions on the getting start with flora page, and had problems with getting it detected on my mac (10.8.2). No x.usbmodem.x entry show up on the Tools menu (just two Bluetooth ones), and nothing special listed on /dev/tty*.
I tried installing newer FTDI drivers and they are loaded but nothing new shows up. If anything, the entry /dev/ttys002 got a new timestamp when I reloaded the FTDI driver.
The green light is on (steady) and the red one is blinking. What else am I missing?
Update: I also tried using the regular Arduino ide on ubuntu and copied board.text and the flora variants dir into the arduino ide's dir. Serial Port from the tools menu is disabled and when running lsusb, I don't get my device listed.