i wired sd breakout to micro as...
--- micro micro
sd icsp pins
-- ------ ------
v5 v5
gnd gnd
do - miso
clk - sck
di - mosi
cs - no place on icsp to connect.
i researched and indicated that ss is mapped to rx led/ss micro pin.
I hesitate to try and would like to ask someone with experience in this area.
thanks
no ss for icsp connections and sd breakout
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- wlab
- Posts: 35
- Joined: Thu Mar 08, 2012 11:20 am
no ss for icsp connections and sd breakout
Last edited by wlab on Wed May 15, 2013 5:53 pm, edited 1 time in total.
- adafruit_support_mike
- Posts: 67485
- Joined: Thu Feb 11, 2010 2:51 pm
Re: no ss for icsp connections and sd breakout
You're going to need to slow down and add the words that have meaning for people who aren't at your workbench or inside your personal head. Right now you're posting the kind of notes that I jot down during a 3am debugging session then can't understand when I wake up the next day.
- wlab
- Posts: 35
- Joined: Thu Mar 08, 2012 11:20 am
Re: no ss for icsp connections and sd breakout
Sure, how do I connect the 6 wires on the sd breakout board to the arduino micro ?
- adafruit_support_mike
- Posts: 67485
- Joined: Thu Feb 11, 2010 2:51 pm
Re: no ss for icsp connections and sd breakout
http://www.ladyada.net/products/microsd/
That shows connections to a basic Arduino, but the pins will be the same on the Micro.
That shows connections to a basic Arduino, but the pins will be the same on the Micro.
- wlab
- Posts: 35
- Joined: Thu Mar 08, 2012 11:20 am
Re: no ss for icsp connections and sd breakout
it didnt work, i wired the breakout to 10 to 13 on the micro and tried running the cardinfo sketch from the tutorial.
the cardinfo sketch say..
** Leonardo: Connect to hardware SPI via the ICSP header
Pin 4 used here for consistency with other Arduino examples
i wired the breakout to 10 to 13 on an UNO and cardinfo sketch worked ok.
What do you suggest
the cardinfo sketch say..
** Leonardo: Connect to hardware SPI via the ICSP header
Pin 4 used here for consistency with other Arduino examples
i wired the breakout to 10 to 13 on an UNO and cardinfo sketch worked ok.
What do you suggest
- wlab
- Posts: 35
- Joined: Thu Mar 08, 2012 11:20 am
Re: no ss for icsp connections and sd breakout
Mike, (sorry for almost dup post) read the documentation fully and micro running great...... thanks for helping and pointing me in the right direction.
- adafruit_support_mike
- Posts: 67485
- Joined: Thu Feb 11, 2010 2:51 pm
Re: no ss for icsp connections and sd breakout
Glad to hear you have it working.
Please be positive and constructive with your questions and comments.