I read the default I2C address for the "Adafruit 16-Channel 12-bit PWM/Servo Driver - I2C interface - PCA9685" is 0x40.
I have two other devices on the I2C bus at 0x40 and 0x68. Is it difficult to change the address of the Servo Driver? What register do I need to adjust and what are safe values for a servo driver new address?
Thanks!
I2C Address: Adafruit 16-Channel 12-bit PWM/Servo Driver - I2C interface - PCA9685
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
-
- Posts: 2
- Joined: Thu Jul 25, 2013 11:03 pm
- adafruit_support_bill
- Posts: 88154
- Joined: Sat Feb 07, 2009 10:11 am
Re: I2C Address: Adafruit 16-Channel 12-bit PWM/Servo Driver - I2C interface - PCA9685
It is easy to change. There are address jumpers on the board: http://learn.adafruit.com/16-channel-pw ... ng-drivers
-
- Posts: 2
- Joined: Thu Jul 25, 2013 11:03 pm
Re: I2C Address: Adafruit 16-Channel 12-bit PWM/Servo Driver - I2C interface - PCA9685
Geeze! I even looked at the tutorials but didn't correlate that address to I2C. Midnight engineering, maybe... Thanks Bill!
Please be positive and constructive with your questions and comments.