Hi,
We are using the motor shield V2 with 2 stepper motors #324 from adafruit.
We are using accelstepper library to manage the 2 motors at the same time.
The problem that we have is the #324 motor doesn't latch or doesn't have enough torque on every motor.
We already used the motor shield V1 with these motors and they have good torque, but seems the v2 shield is not working properly.
Do you have any ideas or adjust to solve this problem ?
Thank you,
Octavio
Torque fail with motor shield V2 and Accelstepper
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- octlerma
- Posts: 2
- Joined: Fri May 10, 2013 8:35 pm
- adafruit_support_bill
- Posts: 88152
- Joined: Sat Feb 07, 2009 10:11 am
Re: Torque fail with motor shield V2 and Accelstepper
What are you using for a power supply? In theory,the bridges on the V2 shield should have less voltage dropout than V1 which should result in more torque. What is the voltage at the motor terminals with the motor stopped?
Please be positive and constructive with your questions and comments.