extech multimeter fuse
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
-
- Posts: 29
- Joined: Mon Mar 16, 2009 6:59 pm
extech multimeter fuse
What is the fuse that goes with the extech multimeter ex330 - and do you sell fuses for it -- what is the part number?
- adafruit_support_bill
- Posts: 88096
- Joined: Sat Feb 07, 2009 10:11 am
Re: extech multimeter fuse
We do not stock replacement fuses for the Ex330.
Fuse values are listed in the manual: http://www.adafruit.com/pdfs/EX330_UM.pdf
Fuse values are listed in the manual: http://www.adafruit.com/pdfs/EX330_UM.pdf
REPLACING THE FUSES
WARNING: To avoid electric shock, disconnect the test leads from any
source of voltage before removing the fuse cover.
1. Disconnect the test leads from the meter.
2. Remove the protective rubber holster as shown in the diagram.
3. Remove the Phillips head screw located on the lower back of the
instrument.
4. Flip up the fuse/battery compartment cover to access the fuses.
5. Gently remove the fuse(s) and install new fuse(s) into the holder(s).
6. Always use fuses of the proper size and value (500mA/250V fast blow
for the mA / µA ranges, 10A/250V fast blow for the A range).
7. Secure the fuse/battery compartment cover.
8. Place the protective rubber holster on the meter
Please be positive and constructive with your questions and comments.