Hello,
I have purchased a rePaper 1.44" board and have it wired up to an Arduino Micro. I have wired it according to the UNO connections and have run the sketch and am getting the following via serial and the display is not updating:
Demo version: 2
Display: EPD_1_44
unsupported FLASH chip: MFG: 0x0 device: 0x0
Temperature = 26 Celcius
The onboard d13 LED is flashing rapidly as well
Is it possible to run this demo sketch on the Micro?
rePaper 1.44" - Arduino Micro
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- adafruit_support_bill
- Posts: 88154
- Joined: Sat Feb 07, 2009 10:11 am
Re: rePaper 1.44" - Arduino Micro
It does work with the Leonardo. The Micro should be the same. Be sure to follow the wiring instructions for the Leonardo.
Please be positive and constructive with your questions and comments.