I'm looking at the DC Boarduino schematic and the board itself and see several places where it indicates +5V.
Are all of these from the on-board 5V regulator drawing power from the 2.1mm DC jack?
I have a green light from the power supply, but I don't seem to be outputting 5V from any of the pins indicated. I've tried powering from both the 2.1mm DC and an FTDI Friend.
Boarduino Pinout
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- quade
- Posts: 61
- Joined: Sat Dec 14, 2013 5:03 pm
Re: Boarduino Pinout
Oh, one more thing. I've been able to upload the "blink" sketch, so I'm fairly certain power in general is okay.
- adafruit_support_mike
- Posts: 67454
- Joined: Thu Feb 11, 2010 2:51 pm
Re: Boarduino Pinout
The source of the +5v rail is shown in the "Power Supply" box in this version of the schematic: http://learn.adafruit.com/system/assets ... inosch.png
The basic idea is that you select either the regulator or the USB 5v rail as the power source, but you only want one at a time. All other pins and traces labeled "+5v" tie back to the center pin in the header where you select the power source.
The basic idea is that you select either the regulator or the USB 5v rail as the power source, but you only want one at a time. All other pins and traces labeled "+5v" tie back to the center pin in the header where you select the power source.
- quade
- Posts: 61
- Joined: Sat Dec 14, 2013 5:03 pm
Re: Boarduino Pinout
Awesome. Got it figured out now. Thanks.
Please be positive and constructive with your questions and comments.