Hi, looking for a solution to a shield Style EZ-Link not being visible to any device.
I picked up the EZ-Link shield from one of your suppliers and mounted headers (have rechecked all soldering),however upon installing the shield on a Uno I get the following results,
Conn Led flashes red every two secs
TX Led flashes blue x3 repeatedly (slight pause between each sequence of three flashes)
Have tried the Switch set to both Direct and Soft Serial
Pressing the Pairing button for 5 seconds changes nothing LED wise or otherwise
The unit is not visible to any of my devices.
If I remove the shield from the Uno and power it with just 5v and Gnd the shield just flashes the red conn Led every 2 Secs and is still not Visible to anything.
I subsequently Ordered a Breakout Style EZ-link and simply powered it with 5v and Gnd (Red Conn Led flashes every 2 secs) and it is immediately visible to all my devices.
Any solutions ?
No Visibility of an Bluefruit EZ-Link shield
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- adafruit_support_rick
- Posts: 35092
- Joined: Tue Mar 15, 2011 11:42 am
Re: No Visibility of an Bluefruit EZ-Link shield
Please email [email protected] with a link to this thread for a replacement EZ-Link Shield
Please be positive and constructive with your questions and comments.