Motorshield V2
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- Lakesed
- Posts: 58
- Joined: Tue Mar 11, 2014 7:30 pm
Motorshield V2
I have been using the Motorshield V2 with great success to control stepper and regular DC motors. I have the Motorshield mounted on a Mega 2560. I am attempting to add a 433 Mhz transmitter module. I can operate the module without a problem with the Motorshield removed but it will not transmit when the Motorshield is installed. The receiver module is installed on an Arduino UNO. I have tried using pins 10 and 12 as the transmit pins. with the same results. This transmitter/receiver combination works fine with another UNO board as the transmitter just as it does with the Motorshield removed. I am using the same sketch on all of the combinations I mentioned above, only changing the "board" type when appropriate.
- Franklin97355
- Posts: 23912
- Joined: Mon Apr 21, 2008 2:33 pm
Re: Motorshield V2
Could you post clear pictures of your board and the connections to it?
- Lakesed
- Posts: 58
- Joined: Tue Mar 11, 2014 7:30 pm
Re: Motorshield V2
It is working now on pin 10 with the Motorshield installed, No explanation!
Thanks
Thanks
Please be positive and constructive with your questions and comments.