Hi, I'm just wondering if there is a way to control the Servo Driver through the Arduino via MATLAB GUI
ie. pressing a certain button will turn on the servo, etc.
Adafruit 16 PWM Servo Driver with MATLAB Gui
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
-
- Posts: 26
- Joined: Mon May 26, 2014 11:00 am
- adafruit_support_bill
- Posts: 88097
- Joined: Sat Feb 07, 2009 10:11 am
Re: Adafruit 16 PWM Servo Driver with MATLAB Gui
That board is controlled through i2c via the Adafruit PWM-Servo library. You would need a MATLAB component on the Arduino to translate the GUI command into a library call.
-
- Posts: 26
- Joined: Mon May 26, 2014 11:00 am
Re: Adafruit 16 PWM Servo Driver with MATLAB Gui
I'm a bit new to this so I'm not sure what you mean by a MATLAB component to translate the command ? =/ Thank you
- adafruit_support_bill
- Posts: 88097
- Joined: Sat Feb 07, 2009 10:11 am
Re: Adafruit 16 PWM Servo Driver with MATLAB Gui
Mathworks has components to interface with with Arduino libraries for various shields. Here is one example: http://www.mathworks.com/matlabcentral/ ... or-shields
I don't know if they have support for our servo driver yet. Mathworks support should be able to help you out there.
I don't know if they have support for our servo driver yet. Mathworks support should be able to help you out there.
Please be positive and constructive with your questions and comments.