I am using an Adafruit 2.8 touchscreen TFT display as my project interface.
I would like to display the IP configuration of the Adafruit CC3000 on the TFT, but it seems that the CC3000.printIPdotsRev function is hard coded to output to serial only.
Any suggestions on how to redirect the output of that function to the TFT?
CC3000 redirecting printIPdotsRev output
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- adafruit_support_mike
- Posts: 67485
- Joined: Thu Feb 11, 2010 2:51 pm
Re: CC3000 redirecting printIPdotsRev output
The best solution is to create a new function that uses the same basic logic as printIPdotsRev() but writes data to the TFT.
The code necessary to make a TFT visible to the CC3000 library would be larger and more complicated than the new function.
The code necessary to make a TFT visible to the CC3000 library would be larger and more complicated than the new function.
- unbound
- Posts: 18
- Joined: Sun Jan 12, 2014 9:51 pm
Re: CC3000 redirecting printIPdotsRev output
Thanks. I thought so.
I'll just put it on my list!
I'll just put it on my list!
Please be positive and constructive with your questions and comments.